Posted by BLINDHAWG on April 22, 2008 at 20:48:38 from (74.230.195.177):
Opinions please. I have 40 acs of neglected pasture I'm "restoring". Lots of 2" saplings which hate tractor tires. I need new rear tires on my Ford 640, but I hate to put new tires on and ruin them. What if, I was to take two old tires some what larger than mine and remove the bead and side wall and wrap the tread around the partially deflated tires. The ends would be bolted together with carriage bolts (round head to the inside, nuts out). Reinflating the tires would make the treads fit snug on the tires. Treads would provide traction and protection. I know, there are products out there to obtain the same results,i.e.,forestry tires, liners,foam, etc. but they're expensive and I love the challenge to solve a problem cheap! What do you think??? Would it work? Anybody ever try it? Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.