Posted by paul on March 16, 2008 at 22:23:35 from (66.44.132.218):
In Reply to: Plowing problems... posted by digii3 on March 16, 2008 at 18:48:34:
Dad had 400 lbs of weight on the land wheel (left one) to plow with 3-16 on his Ollie 88 - similar setup to what you have. Then he put the rock box on that side of the tractor and added more weight.......
What shape are the tire treads on your tractor? Worn down to slicks, or good tread?
Sounds like the ground is a little wet to plow.
How deep are you putting the plow? Should be plowing 1/2 the depth of a plow bottom - your 14 inch plow bottoms should be going about 7 inches deep.
Which wheel is spinning on you? Typically the one on land (left) if it is wet or you don't have enough weight on the tractor. You could have the plow real off-center & only pulling with one tire, but that is not normal for a 3-bottom plow.
Hyd: Um, belly pump is only a one-way isn't it, you said you were runinng a 2-way cyl????
Maybe explain the hyds a little better, I'm not clear on what the problem is.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.