Posted by Gene Davis (Ga.) on March 04, 2008 at 10:51:44 from (75.104.46.36):
In Reply to: avery general posted by RroBb on March 04, 2008 at 06:12:33:
The General was Cletrac's(Cleveland Tractor Co.)venture from the world of track type tractor into the wheel tractor world. They did not continue,but sold the General blueprints and tooling to The B.F. Avery Co. of Louisville, Ky. who were implement manufacturers for a lot of firms. These leading inplement manufacturing compaies of longtime fame were known as short line manufacturers because they did not build power plants. The General became the B.F. Avery "A" tractor with a few minor changes. The history of the Avery Co. is long and productive. The B.F. Avery Co. Of Lousiville, KY. is not to be confused with The Avery Co.of Peoria,Illinois who built both steam and gas engines. The B.F. Avery Co. was purchased by Minnieapolis-Moline who produced the "BF" which replaced the Avery model "R" which was an advanced "A". I owned a "BF" for a couple of years and also an Avery"A" which I managed to trade for an Earthmaster I wanted badly. M.M.already had a model "R" in therir lineup,so they changed the designation to "BF" Search the archives on this site for posts made by a guy Calling himself "Alberta Mike" and e-mail him to ask if he has a copy of the history of the Avery and General tractors available that he compiled about the time he retired from school teaching.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.