Do the front first. Buy new blades from a local dealer. Most all of them carry an aftermarket line that will suffice. Measure the gang bolt size.... then note that most aftermarket blades are made to fit two sizes of gang bolt with the square holes offset from one another at 45 degrees. MAKE SURE THAT YOU USE THE LARGER OF THE TWO HOLES IN THE BLADE as using the smaller hole will result in the blades spinning on the gang bolt. ie... if the blade has a 1" hole and a 1-1/8" hole and your disc has the 1-1/8" gang bolt... that's the blade you need, not the one that has both a 1-1/8" hole and 1-1/4" hole. Those will be spinners... Replace the bearings while you're at it. Should take 1/2 a day or so to do the front gangs. I'd probably replace the gang bolts as a matter of principle at this point. I've had too many old ones break on me. Tighten it all up and make sure that the bearings and hangers do not prevent the spools from clamping together. You'll need to loosen the hangers to get everything tight on the gang and then retighten the hanger bolts. Again, the job could take anywhere from a couple hours to a day depending on how fast you work, how bad it is and what you try to save...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.