Posted by trucker40 on January 08, 2008 at 06:54:16 from (69.152.33.76):
In Reply to: perkins 236 sleeves posted by PJBROWN VT on January 08, 2008 at 05:36:51:
I have pulled dry sleeves in a Farmall H.I took 1 of them out in pieces.I saw somewhere on this website where they showed a chisel that was made just for that.It was kind of thin on the end of it,as it went in between the sleeve and the cylinder it had a raised up place on it that cut the sleeve. I have worked on motors with wet sleeves and it was no trouble to pull sleeves out with a sleeve puller.Pulling dry sleeves was a lot harder.I ended up making a piece that fit over the end of the sleeve then I took a piece of big threaded rod and used that for a puller with some piecees of solid square metal on top.I took a nut with some washers and tightened it with the piece I made on the bottom,then tightening up the nut on top it would pull the sleeve right about the time I was getting scared that it would strip the threads,it would move just a little,sometimes even then only after I got under it and beat on it with a big hammer and a big piece of rod to get it to move at all.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.