Posted by paul on October 27, 2007 at 08:31:45 from (66.44.132.218):
In Reply to: I'll figure it out posted by Lanse on October 27, 2007 at 07:12:03:
That is a common problem, newer plows got more & more distance between bottoms & more height for the beam.
The coulters are often the problem, they need to be LARGE. Old plows typically have the coulters worn down to little disks, don't cut deep enough to cut the stalks.
They need to be adjusted right. Slightly to the left of the edge of the bottom. Deep enough to cut, not so deep the bearing drags on the ground.
The whole plow needs to be set so it is level when you are plowing. This involves your right 3pt leveler and the top link.
The plow needs to follow the rear wheel properly. You can shift the plow left or right with some bolts or clamps on the hitch bar, typically. Wheel need to be in the furrow, and plow needs to be following properly to cut furrows.
Rust on the bottom, as mentioned, makes for very, very hard plowing. Find some sand or dry soil to get the plow shiny. It will plug up with dirt, & then trash, when rusty or painted. Gotta get shiny.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.