Posted by Mathias NY on September 27, 2007 at 19:14:41 from (66.66.157.207):
In Reply to: tractor for snowblowing posted by jeff vanderhorst on September 27, 2007 at 16:21:17:
I think it depends on how much snow 'normal' is. Here in Rochester, NY clearing 1' of snow is not unusual but 2' of heavy stuff is pretty uncommon. As such you don't need 50hp for a 6' rear mounted blower. We have been using a 6' John Deere blower on the back of a John Deere 900HC, which is only 23hp, for 15 years now without issue. My boss has been using a 6' Loftness (sp?) snowblower on the back of his Kubota L2640 (also 23hp) for about 10 years without issue.
Slow reverse is a must, live 3pt hitch is also a must, live or 2stage clutch is also a very good idea. Hydrostatic would be ideal, but may be expensive and may not ideal for some of the other work you will want the tractor for.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.