Tractor Talk Discussion Board |
Cummins Diesel Fuel Cutoff Question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Howard H. on July 20, 2007 at 20:13:04 from (69.55.24.141):
Can anyone explain about the fuel cutoff on an 855 Cummins diesel?? It's a common truck motor and we have one in the 895 Versatile. It's not getting fuel - not sure why. The fuel line is clean and flowing, new fuel filters, and the engine will start on ether but not run on diesel. The cutoff is a small heavy electromagnet with a single wire to it. We're getting 12 volts with the switch on. The electromagnet apparently pulls a small quarter-sized disc against a springy plate that cuts the diesel on and off. The magnet is throwing a field with juice - do they still "go bad" beyond that? Are they common to fail? The cutoff seems to be plumbed more to the side of the fuel return line instead of the feed line after the filters on the tank side. I don't really understand why it would be designed like that. Thanks for any info, Howard
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|