Tractor Talk Discussion Board |
Maybe I'll stick to the hydra-swing...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Don-Wi on July 12, 2007 at 00:45:02 from (69.217.57.42):
Today I showed my dad a little on how to run the hydra-swing haybine so I could go to work (he's never run a hydra-swing before) He made 1 round with me riding shotgun to show him this & that& he did alright for his 1st time. Then he did another with me on the end of the field just watching. Well, somehow he lost the lynch pin that held it onto the drawbar extension and when he was turning and swinging, he caught that big long toungue with the rear tire and dropped it on the ground. Only burst 1 Hydraulic line, a steel one about 4" up, so I'll have to get a hose with a custom fitting on it to fix that... at first I thought he pulled apart the supply hose coming from the reservoir to the pump... Oh well, maybe I'll just keep cutting the hay myself. Not mad or anything, just a little bit of a learning curve with one of those monsters... I've hit the tire many times myself, just never lost that lynch pin.... Maybe I'll go to using a double-nutted bolt... Donovan from Wisconsin
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|