Tractor Talk Discussion Board |
Re: Boy did we pull a good one
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by K.B.-826 on April 16, 2007 at 21:58:29 from (24.180.143.209):
In Reply to: Boy did we pull a good one posted by grazer on April 16, 2007 at 19:14:43:
Just last week I was replacing hyd hoses on a loader. I started up the tractor, raised and lowered the loader a few times, tilted the bucket up and down a few times, all was well. I was about to back out the door when I got the bright idea to grease the loader. Got down to the last two zerks, which were on the rod ends of the bucket cylinders, had to raise the loader and tilt the bucket to get on them. I shut off the tractor and was climbing off to grease those two last fittings when I heard a loud pop followed by a blast of oil. Parts guy didn't get one of the ends pushed onto one of the new bucket cylinder hoses far enough before crimping. My workbench right in front of the tractor got the worst of it, but there was oil 15 feet up the shop wall and everywhere within a 20 foot radius. Took over an hour to clean up, but I'm just glad nobody was walking past in front of the tractor.
Replies:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|