Tractor Talk Discussion Board |
Re: Removing cylinder sleeves
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by rrlund on April 13, 2007 at 07:05:12 from (216.46.213.86):
In Reply to: Removing cylinder sleeves posted by MTrimOhio on April 12, 2007 at 18:25:40:
That has wet sleeves,so you don't have to be concerned with breaking them. When they pop loose,they will lift out. Yes,we borrowed a slide hammer type puller one time before I built my own for those Olivers. It worked best to hang it up on the chain fall to keep constant pressure on it,then just whack away. The one that I made,I used a piece of 1/2 inch plate,cut two flat sides on it and used a salvaged joint from a swivel type breaker bar so I could drop it down from the top. I welded it to half of an old U bolt from the spring of a big truck. It has fine threads so it pulls strong and slow. The top plate that sits on the top of the engine is just flat plate with two small pieces of channel on the sides. Like I said,with those wet sleeves,they don't have to be lifted very far.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|