Tractor Talk Discussion Board |
Re: Oliver 1600 clutch slipping
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by rrlund on April 04, 2007 at 17:02:02 from (216.46.210.24):
In Reply to: Re: Oliver 1600 clutch slipping posted by Dave Anderson on April 04, 2007 at 16:08:51:
Whoa whoa,hold the phone! I was going to wait and let somebody on the Oliver forum answer all the questions,but I have stop this in it's tracks. You do NOT SPLIT an Oliver to get to the clutch! We lift the motor,turn it sideways in the frame,let it down enough to steady it,then lift the hydra power unit off with a cherry picker. If you aren't loosing fluid from the hydra power,it is most likely the rear main. BEFORE you go to the extreme of taking it out,you can get some adjustment in the linkage. I've taken some up that way before.Especially if the pedal is all the way up like you say. JUST DO NOT even think about splitting that tractor. It is NEVER necessary to do ANY work on an Oliver.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|