Tractor Talk Discussion Board |
Deere 1020 vs Industrial 400
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Twigs_22 on April 01, 2007 at 21:40:46 from (72.19.170.1):
Hi- I am looking into two different deere tractors right now. The deere 1020 is about $1,300 less then the industrial tractor. The industrial tractor may be a little to big for what I am looking to do. The 1020"s hydralics work great until your drive the tractor in high speeds for a hundered yards or more and then the hydralics are very slow but eventualy return to working order. The pto is often a challenge to engage on the 1020. The 400 does not have any obvious issues but I am also no expert. It does leak oil some. What are everyone"s thoughts on these tractors... which was a better model... what should I expect to pay for one in colorado (both with loaders). What else should I check out before buying. Thanks
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|