Tractor Talk Discussion Board |
Re: Allis Chalmers D17 Series IV hydraulics
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JMS/MN on January 24, 2007 at 10:24:19 from (204.73.106.15):
In Reply to: Allis Chalmers D17 Series IV hydraulics posted by Jon Wolter on January 23, 2007 at 08:28:05:
If you have a Series IV it has an independent hydraulic pump on the right side, where the belt pulley would mount on earlier Series. You have live hydraulics whenever the engine is running-foot clutch pushed in or not. For your all hydraulic loader to work you need two hydraulic circuits, at least one of which must be a two-way to run the bucket cylinder(s). Many loaders use a one-way for the boom lift. Not sure which valves were standard and which were optional, but you certainly can set up your system to do what you want. Do you have 3 hyd levers? One for the 3pt, the other 2 run separate valves?
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|