Tractor Talk Discussion Board |
Re: Old 24 planer
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by VaTom on December 22, 2006 at 15:21:34 from (64.4.122.168):
In Reply to: Old 24 planer posted by Lee Boland on December 22, 2006 at 14:48:42:
Hi Lee, Chances are good you have a great machine. Half of my stationary woodworking machines are babbitt bearings, most of the rest were converted to ball-bearing. Heavy cast iron makes for nice machinery. FineWoodworking had a good article some years ago about pouring babbitts. I'll try to find it for you. I haven't yet needed to repour any babbitts, only reduce shims to tighten them up. Can't imagine your machine casting doesn't have the mfg. name. Not that it matters much. You mention belts and pulleys. Was this a jackshaft driven machine? I recently arranged for a friend to buy one here. My 24" planer is early 50's and weighs 4500 lbs, ball-bearings. The great part about pouring babbitts is if you screw it up, no problem. Just do it again. You won't hurt anything. I guess you know that fire might have affected the knives. I'll get back to you. Can scan the article if you'd like.
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|