Tractor Talk Discussion Board |
Re: Att'n Allan in NE
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Johnnie T on December 11, 2006 at 17:40:02 from (65.54.154.112):
In Reply to: Att'n Allan in NE posted by Johnnie T on December 11, 2006 at 12:17:31:
Bob dist. shaft turns, the magnet wheel is what I think is the black plastic ring with a green tape at the bottom & it is all the way down & appears to be lined up w/ the ignitor, now about the air gap, the ignitor is fixed to the plate with small bolts hold it in place & tight to dist body there is no way to adjust the air gap that I can see there is no gr.jumper wire just a red wire to + post & black to - post of coil distributor is tight & was installed new 2 yrs ago. I am thinking about installing a new gr. from battery to starter mounts and see if that helps the problem, but at this time I don't think I have agr problem Thanks for all of the help.
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|