Tractor Talk Discussion Board |
Re: Tractor tire sizes, how to figure
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by iowa_tire_guy on December 03, 2006 at 15:43:46 from (216.248.102.181):
In Reply to: Tractor tire sizes, how to figure posted by Midwest redneck on December 03, 2006 at 15:02:47:
In bias tires for the time being at least you have 2 numbers. The first number is the width of the tire. An 11.2 will be 11 and 2/10 inches measured at the widest point in the bulge of the tire. (as in you are standing behind the tractor) Older tires do not have the decimal point and they are measured at the bead width such a 10 inch tire goes on a 10 inch wide rim and is the same as an 11.2. The second number is the diameter of the bead. The bead of the tire is the part that makes contact with the rim.
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|