Tractor Talk Discussion Board |
Re: OT-1991 Olds revisited - Bob
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Richard H. on November 21, 2006 at 07:28:57 from (208.70.45.167):
In Reply to: Re: OT-1991 Olds revisited - Bob posted by bradk on November 21, 2006 at 06:03:48:
Brad this is a HEI with external coil and it has a 2 pin and a 4 pin conn. at the dist. I will gleefully go out and look for this one wire. The 2 pin conn. I was using is the only way I could get the timing right before shut down. Also it is probable the conn. I"m using is actually one wire if it is a loop thru a switch or sensor as part of an I.O circuit. IMHO this would not let the cpu tell the ign control module what the timing should be until it is reconnected. I will post back and let all know how this comes out. Richard
Replies:
- Bradk Richard H. 10:56:18 11/21/06
(0)
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|