Tractor Talk Discussion Board |
Well dang it Bob
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Richard H. on November 20, 2006 at 11:10:33 from (208.70.45.167):
In Reply to: Re: OT-1991 Olds revisited - Bob posted by Bob on November 20, 2006 at 07:24:49:
Ok I did this again "Then, following the procedure on the emissions decal, unplug the "set timing" connector, set the timing with a timing light, shut it down, connect the "set timing" connector back up, and see where that gets you." As you said. Doing that the timing is set to 0 deg and I have 22lbs of vacuum. Shut it down , do the above and go to start it and the timing is a mile off. Sooo.., something is telling the control module to advance the the timing. Could I have put the distributor back together wrong? You have to take out the shaft to put in the pick-up coil which means the magnetic ring also to do this. In my terms this is a proximity switch set-up. The pick-up coil is cut dry as far as fit and has a little black dot on it. The mag ring has a tiny stamped dot on it also and I aligned them up when the ring went back on. Right, wrong?,does it matter? Sheeez this fun.. Richard
Replies:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|