Tractor Talk Discussion Board |
Re: Will bleach eat rust?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on November 18, 2006 at 16:22:40 from (66.173.50.118):
In Reply to: Will bleach eat rust? posted by super99 on November 18, 2006 at 16:00:30:
In my opinion bleach will do very little to penetrate that bearing. If the bearing is going to be replaced, slice it nearly in half with a abrasive cutoff saw (maybe in a 7-1/4 elecrric saw, or a side winder grinder) on one side and use a cold chisel to split it. If the bearing is good, warming it up with a torch uniformly till it is way to hot to touch, but not starting to change color may loosen it enough to drive it off. Tou can also drive on it with a suitable piece of pipe in the opposite direction you need to go, then polish the vacated spot with 250 open coat cloth and lube it befor driving it off in the way it needs to go. If the blades are in the way, smoke them off with a blue flame wrench and have at it. Good luck, JimN
Replies:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|