Tractor Talk Discussion Board |
Re: High Efficiency , Low Hours
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by NO tools on November 11, 2006 at 13:55:26 from (71.79.44.154):
In Reply to: Re: High Efficiency , Low Hours posted by Allan In NE on November 11, 2006 at 12:48:34:
Well AH let mee see. Better let me go out here and kick this ole 706 around a little and maybe he'll kick back with some sence. I am thinking that there is a 2 spool valve that we can mount on a small plate out side the cab. Then we can run the control rods through a small hole in the side of cab spot weld a small braket to that strut above the ash tray to put the levers on? NOW? i'am THINKING??? if we need a regulator i have for some reason got it in my mind that on a super m that had the auxiliary control valve they had a small in line regulator infront of the valve? I'am going out here and kick ole red around for awhile THANKS NO tools
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|