Tractor Talk Discussion Board |
Ok, just re-read your post for the 6th time, and..
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Old Pokey on November 11, 2006 at 08:20:04 from (216.99.219.239):
In Reply to: Re: Hydraulics Questions posted by Old Pokey on November 11, 2006 at 08:03:38:
I think I better understand your situation now, maybe.??? Ok, you've "converted" the valves to one-way, so the oil is supposed to flow from the non-work port to the out port when lowering the loader or tilting the bucket downward, right? You asked about simply plumbing them in series. No problem. As far as getting full pump "volume" to the cylinders, those valves you bought need at least 1/2" work ports. I think a 3/8" work port with a hose of any length hooked to it, might restrict the flow enough that you'll have problems. Though, you did'nt state the pumps size or output, so I'm guessing it should be at least a 20-25gpm size, right? What size ports are on the loader lift cylinders?
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|