Tractor Talk Discussion Board |
Re: What dose a John deere 1050 need to have so it
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gene Davis (GA) on October 26, 2006 at 21:16:46 from (70.41.83.26):
In Reply to: What dose a John deere 1050 need to have so it can posted by the kisco kid on October 26, 2006 at 20:43:21:
You have to add the selective control valves. I added a loader on my 650 JD, and it was impossible to steer it with the bucket full, so I had to add a power steering kit from John Deere. IT WASN"T CHEAP EITHER. It had all the steering components and the provisions for the hydraulic supply to the loader valves. It taps into the lift housing on my 650 and you add an inside plug and a fitting for pressure oil,and it returns back into the side of the transmission case. I used a modified IH 1050 series loader and it worked well after I added the power steering and used radial automotive front tires instead of the regular ribbed tractor tires that tore up too much ground when you turn loaded. The valves should be with the loader.
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|