Tractor Talk Discussion Board |
Re: I'm just not cut out for doing this
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ol Chief on October 22, 2006 at 16:39:26 from (69.91.92.199):
In Reply to: I'm just not cut out for doing this posted by old on October 21, 2006 at 17:26:17:
JustGrin and Bear it.For the greater part of my lifetime I had been training young fellows who had little knowledge except that from books.Most came from Maritime Academy or College.After several years I started reminding my assisants and fellow workers that we all had to be young (once ).Those whose Dads were Attorneys,Doctors or Accountants,usually progressed later than the guys whose Dads were Pipefighters,welders or mechanics of some trade,usually were at an advantage.Your boy is blessed in that respect.I will bet he'll do well.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|