Tractor Talk Discussion Board |
Ford 2000 3 cyl. gas problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Brian630 on October 20, 2006 at 09:33:30 from (216.227.60.172):
Over a month ago my Ford 2000 gas 3 cyl. tractor quit on me. So far rebuilt carb, new selenoid, new coil, drained gas tank and cleaned sediment bowl. What I need to do now is replace plugs, wires, points, condensor, rotor cap. Now my problem. Took off distributor cap and rotor. I can't get to the points because the dust cover won't come off. Everyone tells me it should just lift out if you pull on it. Tried to pry it off with a screw driver, tap on it but it will not come off. There is a metal ring around the top of the cover. Second problem, I didn't mark the plug wires, now I don't know which goes where. Firing order is 1 2 3 and the rotor turns counter clockwise. There is a one on the rotor cap. And lastly I need to know the gap for the points and plugs. If anyone could help me I would really appreciate it. Not to many warm days left so I want to get it going asap.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|