Tractor Talk Discussion Board |
Re: six cyn engine crankshaft
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Easy1 on October 06, 2006 at 05:12:39 from (198.208.159.19):
In Reply to: six cyn engine crankshaft posted by confused crank on October 05, 2006 at 19:33:37:
I work in an engine plant. We make crankshafts, v8's now have done v6 previous. If your crank is really bent more than .010 or so, I believe the engine would be very tight. Our runout spec for the pins to the main is only .001. We have a gage that holds the crank vertically, so it doesn't sag in the middle during inspection. I will say that I have never seen a crank that was assembled into an engine & removed make spec. We never would reuse a crank here. Cranks are surprisingly fragile.
Replies:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|