Tractor Talk Discussion Board |
Dumb question # 387
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Delbert on July 12, 2006 at 07:55:37 from (65.164.58.20):
What my question is what would it take to put a 300 rearend behind a super h motor? The super h is a early 53 model stage 1. My neighbor has a 300 that i could buy at a reasonale price think the ta is ok it has some oil leaks. My super h needs some tranny work also. I have veiwed the archives it seems it wouldn,t be a big job. Another question i have is would i need to change timing gears or would this motor have the heavier gears? It doesn,t have live hydralics. I would like to put the live pump on the h motor. The motor in the 300 is in real bad shape needs complete overhaul. My thinking is that i could have a more modern tractor at not to much cost. Thanks again for your help Delbert.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|