Tractor Talk Discussion Board |
cut out to voltage regulator
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by bill in Md on June 22, 2006 at 09:22:41 from (64.26.76.21):
i just converted my 52 wd form charging cut to voltage regulator. i polorized it from arm on gene to batt post on VR. before starting enging i am getting a reading of 6.3v on the battery. amp meter before starting showing zero, turn on head lights showing slight discharge. start engine, high idle; i get 6.5 v. at the VR. Amp meter showing slight + charge. turn on headlights amp meter goes back to zero. unhook the batt post on VR and get a reading of 7.5 v. question is, why are my reading so low even with the headlighs on? all wires are new and the battery is good. can someone help an idiot out.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|