Tractor Talk Discussion Board |
Re: 2 or four inch pipes?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RustyFarmall on March 30, 2006 at 07:58:47 from (216.248.75.151):
In Reply to: 2 or four inch pipes? posted by Tim Shultz on March 30, 2006 at 07:44:33:
If your truck did not have a catalytic convertor to begin with, it does not need one now. Glass pack mufflers are acceptable in my part of the country, don"t know about your"s. Your biggest problem with noise will be local city ordinances. You are totally dreaming when you speak of 4 inch or 6 inch diameter pipes. First, you probably won"t find a muffler shop that even has anything of that size, and second, that large size pipe will be a very difficult, if not impossible fit underneath the truck. 2 1/2 inch diameter pipe will be more than adequate, and 2 inch would work just fine also. Unless you just plain want noise, go with something other than glass packs. There are mufflers that will perform better with less noise.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|