Tractor Talk Discussion Board |
Re: wd45 carb missing and sticking float...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bill(Wis) on December 28, 2005 at 21:04:27 from (162.84.135.215):
In Reply to: wd45 carb missing and sticking float... posted by Gary r. voigt on December 28, 2005 at 20:36:32:
Sometimes the needle valve that allows gas to run into the float chamber sticks in the up (closed) position. This can cause sporatic missing or outright engine stoppage if it sticks tight. I can usually determine if that's the problem by tapping on the side of the carb. That's usually enough to unseat the needle valve and get it going again. Fixing it? I honestly think it just needs to be run more. But, cleaning and replacing the needle valve has helped. It usually happens at the worst possible time.
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|