Tractor Talk Discussion Board |
Re: OT traction ballast how much weight in pick-up
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by thejdman01 on December 14, 2005 at 15:26:13 from (64.12.117.7):
In Reply to: OT traction ballast how much weight in pick-up posted by Tim B From MA on December 14, 2005 at 10:07:06:
i run 2000 lbs, cut a chunk of counter weight off of an old crane. i used to put 900 in the back and htat jsut wasnt enough. 900 would work ok but if i hang that old plow 2 feet infront of the axle there wasnt enough in the back put the 2000 in works jsut right. the plate lays in there flat is the exact size of the bed ie doesnt slide around hit gate hit front of box works well. go to an old construction site etc w/your own torch and usually theyll let you have it or have it for scrap price whatever you cut off.
Replies:
Home
| Forums
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|