Tractor Talk Discussion Board |
Re: John Deer 4010 PTO Handle
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by norman alan on December 11, 2005 at 14:32:19 from (72.5.3.188):
In Reply to: Re: John Deer 4010 PTO Handle posted by R. John Johnson on December 11, 2005 at 05:31:48:
Your detailed steps are better than the book. But my question is how can I reach the end I have both plates off the one on top and the one on the key. And also the bottom pan. I can not reach the end of the rode to be able to follow your direction. I put my hand on the left side just next to the key and could not go past 15” down and got stuck. I did try to get the handle out but I couldn’t. I will be able to fix it if I am able to get to it.lol…I will post a photo tomorrow as soon as I get back from the farm. God Bless you.
Replies:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|