Tractor Talk Discussion Board |
Aluminium Foil and Vapor Lock
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tham on December 09, 2005 at 20:28:58 from (203.131.197.195):
Hi, I'm Tham from Kuala Lumpur, Malaysia. I own a very old 1981 Toyota Corolla KE70 saloon, with a 1,290 cc 4K engine. If my email seems out of place here, I'd like to apologize to the forum moderators and other users here. I had been having lots of problems with the engine sputtering and almost dying out in hot weather, so someone said it might be vapor lock. Searching around the net for solutions, I found the following article on your website here : http://www.ytmag.com/articles/artint69.htm At the bottom of the above article, the author, Curtis, mentioned wrapping the fuel line in aluminium foil. I was wondering, would this mean that the shiny side should be facing inwards or outwards ?
I have just wrapped my fuel lines from and to the fuel pump as suggested, and am afraid I might have the shiny side facing wrongly. What might happen if I did ? Thank you very much for any assistance. Best Regards, Tham
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|