Tractor Talk Discussion Board |
Re: FEL hydraulic layout simplification questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by big jt on December 04, 2005 at 06:41:17 from (206.72.54.246):
In Reply to: FEL hydraulic layout simplification questions posted by Cormac on December 04, 2005 at 04:54:28:
I am not specifically familiar with your loader. Westendorf has a similiar setup. It is needed because when unhooking the loader you need control of the cylinders so the hoses need to reach as you back away. Sounds like you are using good sense. Would for sure suggest that you keep the separate valve (controller) I have never been able to use the tractor remote valves very well to feather as well as a separate loader dedicated valve. hope this answer isn't to muddy jt
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|