Tractor Talk Discussion Board |
Re: changing cribs to bins
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by paul on November 30, 2005 at 18:01:44 from (66.44.137.228):
In Reply to: changing cribs to bins posted by dave from MN on November 30, 2005 at 16:52:33:
I have no experience at all, other than what I hear at the coffee shop & see as I drive to farm auctions..... So take it for what its worth..... Shell corn puts much more force on the sidewalls than ear corn does. Be sure you have a good strong frame to begin with. Might need to cable around the bottom a few times to increase strength. Wind plays heck with your bin when it is empty. The sheet tin doesn't get supported much, and a strong wind will push in one side of the new tin - when empty. Typically one hangs vertical sheets insid the bin. As the pressure of the corn expands the tin, the seams like to leak, as well as water in under the bottom - we don't make as good a seal on the bottom with this type of construction as we think we do. Have to be careful or water seeps in, lots of spoilage along the outside. Those are the items I notice from a distance. --->Paul
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|