Tractor Talk Discussion Board |
Re: metal siding
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave Sherburne,NY on October 12, 2005 at 08:43:57 from (170.215.212.142):
In Reply to: metal siding posted by memmo on October 12, 2005 at 07:14:43:
For sheet metal siding, nails or screws go on the flats. Try this put a wire around a nail and drive it all the way into a board as if it was siding nailed on the flats then pull on the wire. Can't move it can you ? Drive one in but leave it out an inch as if it was on the ridges. Put a wire on it at the head and pull, probrobly bends or tears out. METAL ON SIDEWALLS NAILS GO ON THE FLATS,but you probrobly will need a few on the lap joints to hold it tite. On the roof Nails go on the ridges, screws go on the flats .Screws not carefully applied to ridges will distort the the metal. Nails , less likely to leak on the ridges.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|