Tractor Talk Discussion Board |
tractor shifter
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by INCase on September 30, 2005 at 13:15:23 from (209.221.240.14):
THe shifter on my Case 800 has, what I think, is a lot of slop. I"m comparing this to The Case 730 which has pretty tight shift with a nice snap/click into each gear. Is the sloppy shifter due to the shifter, the yokes or the gears? I looked (as best I could) thru the holes between the trans and differential houseing with the differential cover off. from what I could see the gears looked ok but the egdes of the gears looked like the corners radially(where they would first mesh with the next gear) had been filed off. is this wear or were they made like that? If it is wear is it a problem? (haven"t opened the 730 cover yet). Any info/help/advise is appreciated. thanks
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|