Tractor Talk Discussion Board |
Re: Routing of canister oil lines ????
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on August 20, 2005 at 10:10:00 from (64.21.249.40):
In Reply to: Routing of canister oil lines ???? posted by Way Up Here on August 20, 2005 at 09:58:01:
What machine are you working with, and is the filter cannister original, or an add-on? I believe Fram, Purolator, etc., made add-on filter kits for many applications. I would say by far the most common setup is oil ENTERS into the main housing, flows through the filter media, and then exits into the hollow center post, and then out the bottom. Typically, there is a small hole in the center post near the top that serves as a restrictor to prevent too much oil from passing through the by-pass filter setup, and dropping engine oil pressure. Also, this exit port near the TOP of the center post allows air trapped in the filter housing to exit. If it were to be plumbed backwards, fed at the top, and having the oil exit lower down on the cannister side, you would never get much filtration, as you'd have a big air bubble trapped around most of the filter. Take a close look at the unit you have, and note where the ports are, and consider how air would vent, and you may be able to figure out what orientation makes sense! I have a few tractors and machines around with these cannister filters... I'll take a look at how they're plumbed, and post back.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|