Tractor Talk Discussion Board |
Re: Gooseneck for a Half Ton
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Can't even use my name on July 11, 2005 at 20:15:55 from (66.228.102.248):
In Reply to: Re: Gooseneck for a Half Ton posted by big jt on July 10, 2005 at 22:45:52:
I think actually the trailer brakes are the ones supposed to do most of the stopping as this is how you avoid jackkniving yourself. I use a 1/2 ton to pull a 24' gooseneck triaxle with 14 roundbales with plenty of brakes and just adequate engine. Not the most desirable and I don't do it very often but it is a lot nicer to use that gooseneck to haul our skidsteer than to use a bumper pull.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|