Tractor Talk Discussion Board |
Re: OT : Truck troubles
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by What I did on July 07, 2005 at 10:47:42 from (164.58.5.214):
In Reply to: OT : Truck troubles posted by Creston Farmer on July 06, 2005 at 21:03:50:
Lost mine too on Dodge with cummins--twice-- First time I did not have the tool and used a hammer and chisel to tighten the nut, run it ten thousand and lost it again. Second time I made the tool with a piece of three inch drill stem and some quarter inch plate to make the slot bars that go in the slots of the nut. Tightend it down all I could then used a hammer and chisel and gave it a few more whops. Then I used the old nut that got spun off and put it on for a jam nut used the hammer and chisel on it too. There is an outfit in Ft. Worth that has an improved nut over the one that Dodge sells, I used it the second time. Either place you get it they come with red thread locker--use it, lots of it-- First nut I put on took me half a day because of a froze bolt on top of the carrier bearing, finally had to use a dremel to grind it off. Second time took an hour and a half from start to finish. If you go to TDR on the net, they have the parts list and step by step instructions.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|