Tractor Talk Discussion Board |
Re: Valve seats on a Detroit 53 series
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by NC Wayne on July 05, 2005 at 16:29:38 from (64.12.117.7):
In Reply to: Valve seats on a Detroit 53 series posted by Kirk_t on July 05, 2005 at 12:17:17:
I work on equipment for a living and have rebuilt quite a few of the old two stroke Detroits over the past few years. Even so when it comes to the block and head work I leave that to the "professionals". Basically it takes too much special equipment to do it yourself, if you don't do it all the time, and even with the equipment it's too easy to screw something up if you don't have the knowledge to do it right. It may cost a little more to get a reman or to the existing head professionally done but in the long run you know it's right and you not gonna have to pay to do the job twice along with getting a professional to redo something that got screwed up. Just my .02
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|