Tractor Talk Discussion Board |
Okay, now the question of where and how much...
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by old fashioned farmer on June 15, 2005 at 20:25:19 from (4.131.48.139):
Howdy again, Well, with the few replies I got to my R question I gather that my block is shot. So the question now arises, where can I get a replacement. Granted it will be a used one, but where can I find one that is useable? Also, now that I'm having to replace it, what kind of price am I looking at? Lastly, since this is all happening I am seriously toying around with the idea of having whatever block I get bored out and purchasing bigger pistons, sleeves, etc. so as to increase the bore and horsepower. To those in the know, what would you suggest as far as that goes? I've heard mention of replacing the old pistons with 730 or 830 pistons, etc. How much of an increase in h.p. am I looking at, how much cost, and what's the best way of going about getting that done? I appreciate the help folks. God bless. --old fashioned farmer
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|