Tractor Talk Discussion Board |
OT - More Mack truck trailer wiring - longish
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave (IL) on June 05, 2005 at 06:34:21 from (24.15.101.212):
I posted the following on Big Mack Trucks and then thought, why not here where all the really smart a. er people are :) (just kidding). One response was flip polarity and said "I had a one wire alternator so it didn't need anything to switch" Anyway, here's my post: I have a 70 R700 and am hooking up my trailer for my skid steer. I'm familar with positive ground from English sports cars and old tractors, but I'm wondering how others deal with it. First thing was I disconnected the trailer brake battery and hooked things up, and the tail lights woundn't work. Discovered they were LED lights and don't work with reversed polarity. Replace with lights with bulbs. The battery for the brakes has a diode to prevent discharge to the tow vehicle. I suspect I can flip that, but I'd like to make it switchable, because I still want to pull trailer with my Avalanhe at times. I am trying to verify whether the brake "coils" will work with reversed polarity. Now I'm dealing with the split brake and turn wiring on the truck. I bought a module - Hobby - for that purpose, but don't know if it will work with reversed polarity and hate to burn it out trying. Next, I believe, IL law requires the trailer brakes to be working over 3000 lbs. This means I'm going to have to add a brake controller to the truck and this might have polarity issues also. So I'm just wondering if anyone else has gone through this whole mess before? I'm new to the Mack. This is the first forum I found. Is this a good place for these kinds of questions? Thanks to any and all!
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|