Tractor Talk Discussion Board |
Re: 1020 john deere front hood patch
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rustyj14 on June 03, 2005 at 15:29:00 from (209.195.143.107):
In Reply to: 1020 john deere front hood patch posted by Jerry Hancock on June 02, 2005 at 13:04:16:
If your hood is fibreglass, cobble up a form bigger than the hole, to fit inside the hood. Apply a heavy coat of auto body wax to it, then fasten it inside the hood, under the hole! then go to the auto parts store and buy a fibre-glass patch kit. follow the directions on how to use it. Grind the opening back about 4 inches on a taper. Then, soak the cloth in the mixture of liquid and hardener, and apply it in layers, which you should have pre-cut. The first 1 or 2 layers are the key to success. let them harden well (overnite) Grind them some to roughen them, then apply 2 more layers, etc., on and on, until the patch is higher than the surrounding area. After all is hard, grind the patch down to the same contour as the rest of the hood, sand and featheredge it, blow out the dust, prime 4-5 coats, let dry, then go on and sand the primer, and if it looks smooth, paint it! You may need some spot putty on the first primer coats, and that has to dry and be sanded smooth, then primed over! note: if the hood has to go between the side posts at the hood hinge area, loosen those posts, install the hood, then carefully tighten the bolts! do not try to squeeze the hood to get it in the place! by: Rustyj
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|