Tractor Talk Discussion Board |
Hey Zane - help with NAA Hyds
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mstrumpet on May 18, 2005 at 17:16:14 from (204.69.147.65):
I bought a Jubilee last year. It had a bucket on it and it always worked fine with the hitch locked to the drawbar so the 3 pt wasn't able to go all the way up. I would put it in a good position and shut off the hydraulic line with the faucet handle that it was rigged with. Then the 3pt would only work for a little while and then quit. This year I tore the piston assembly apart and put it a replacement "B" type piston as recommended and a new "O" ring. Now it lifts just great the first time and the very next time you try it, it won't lift at all. The old "O" ring was bad, so that was part of the problem, but apparently not all the problem. It was suggested that it may be the "check" valve or unloading valve. Does that sound right? The pump must be OK or it wouldn't lift at all. Any ideas? Thanks Loads - Mike S.
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|