Tractor Talk Discussion Board |
Re: IH 300 width
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on November 30, 2004 at 18:23:52 from (66.60.197.122):
In Reply to: IH 300 width posted by harvested on November 30, 2004 at 10:47:29:
In addition to what Hugh said, they have sliding axles on the row crop (biger one) as well as dished wheels and 2 different rim ridges to bolt to. How much are you willing to go through to set it as narrow as possible for the ride? Second to worst case, it's set with the dishes & rims as wide as possible, you need to support rear end & swap wheels. Worst case, they are set differently from each other (this is common, mine is set with the right side rim narrow for baling/ combining, left side is set wide rim for stablity). You may end up taking the rims and axle clamps apart to move everything 'in'. I believe the wide front end would actually be wider than the rear wheels if you ran the rears dished 'in' so that probably isn't a real world option, tho something you could do for temporary.... Just so you know what you are getting into if you are just given a number for the narrowest setting for a 300 row-crop, it might be more involved than you think... --->Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|