Tractor Talk Discussion Board |
Re: 3 angle valve grinding??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allan in NE on November 12, 2004 at 17:00:50 from (148.78.243.24):
In Reply to: Re: 3 angle valve grinding?? posted by Jon H on November 12, 2004 at 16:40:06:
Hi Jon, That’s what I do too, plus crowd the margin ever so slightly towards the 'head' of the valve from the center of the face. In many applications in fact, the valve face will be ground to a 45-degree cut and will land on a seating surface cut to 46 degrees. This 1 degree of "wedging" effect will actually help in the seal as well as kinda "lock" the valve down during it's time at rest to help the cooling. If you’ll notice, a correctly and properly ground valve/seat assembly will feel almost as though the valve is lightly “stuck” to the seat without the springs and keepers in place. How's things going up there in the great North anyway? :>) Allan
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|