Tractor Talk Discussion Board |
Re: Ford 8N question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on November 07, 2004 at 18:48:02 from (66.163.134.177):
In Reply to: Re: Ford 8N question posted by Chelle Shocked on November 07, 2004 at 18:30:27:
The number you are seeing is a casting number. You need to look carefully at the engine block, where shown in the picture on the site I linked. This number stamped into the engine is the TRACTOR serial number (providing the engine block has never been swapped out). There may be layers of paint or rust over the weakly hand-stamped serial number, but it should be there. Various castings on the tractor have date codes cast into them from when the castings were made. (Could be MONTHS before the tractor was built) I believe there are often visble date codes under the castings that extend out to the LH and RH rear wheels (axle "trumpets"), and, if you are beneath the tractor, looking up, just ahead of the seat area, you will see a rectangular casting bolted to the bottom of the tractor. This is the hydraulic pump base, and it SHOULD have a date code on it. For more "date info", go to the "N" board and type "date codes" into the search box at the top of the page.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|