Tractor Talk Discussion Board |
Re: PTO HP
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JWC on September 18, 2004 at 23:14:08 from (216.78.71.7):
In Reply to: PTO HP posted by Pete on September 18, 2004 at 08:57:32:
The manufacturer selects the gearing of the pto so that you will be able to maintain 540 or 1000 rpm at or near the maximum available power. HP is measured with a dynamometer, which measures force(torque) and shaft speed(rpm). Within whatever reserve the govenor on the engine affords you the maximum engine rpm will only occur at something less than the maximum load. The manufacturers do their best to maximize the amount work that can be obtained from each machine. The govenors are not set to limit the engine speed to the point where maximum power is produced because all tasks do not require maximum power or torque.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|