Tractor Talk Discussion Board |
New rebuild not starting
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve O. on August 31, 2004 at 15:01:32 from (66.37.197.102):
Hope somebody can help me out? I have just completed atop to bottom rebuild on an Oliver 232 6cyl diesel.Every thing has been replaced. The injector pump has been refurbished by a factory auth. service. it wants to fire but just sputters. It ran for about 5 seconds.I have bled the fuel system many times. I have found some leaks on the return lines. Will be replacing all before next attempt.This is my first diesel and although I under stand the concept of the injector pump,I don't know if there is something I should be fiddlin on it while cranking. I have the throttle wide open per recomendation or the folks who rebuilt it. I am also going back to square one on setting the timing.When I originally set it i Watched the #1 intake drop and dialed it to the top on that revolution, and stopped at 4deg BTDC. Ihave since obtained a correct book for my machine and it says I should be at 2deg ATDC. By the way not that it makes any differance my machine is a White 2-63 Industrial TLB. Thanks for any help.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|